Skip to:ContentBottom
On the selection of material model for 3D printed plastics için kapak resmi
On the selection of material model for 3D printed plastics
Başlık:
On the selection of material model for 3D printed plastics
Yazar:
Yorulmazlar, Berika, author.
Yazar Ek Girişi:
Fiziksel Tanımlama:
xi, 85 leaves: charts;+ 1 computer laser optical disc.
Özet:
In this study, the behavior of suitable material models which fulfil the need of representation of static and dynamic constitutive behavior ABS plastic produced with Fused Deposition Modeling (FDM) method was investigated. The accuracy of material model strongly depends on the accurate determination of its constants. These constants were obtained by conducting quasi-static and high strain rate experimental studies. The high strain rate tests of FDM built ABS samples were performed using split-Hopkinson pressure bar (SHPB) and split-Hopkinson tension bar (SHTB) and gas gun set-ups. Numerical models were conducted by using the commercial explicit finite element code LS-DYNA 971. Raw data obtained from experiments at low and high strain rates, were reduced and defined in material models. ΜΑΤ_24, ΜΑΤ_81, ΜΑΤ—187 material models were considered in numerical models to investigate the constitutive behavior of the FDM b^ilt ABS material. Good correlation was observed between the numerical and experimental data with the use of selected material models. Then, Generalized Incremental Stress-State dependent damage Model (GISSMO) was selected to characterize the failure behavior of the FDM built ABS. Parameters and curves that defines the state necking and failure occurs at, were found by using optimisation tool, LS-OPT. After observing successful match between the numerical and experimental forcedisplacement curves, GISSMO parameters were defined in SHTB and gas gun numerical models. The results showed good correlation for also the gas gun and SHTB tests in terms of failure behavior, eventually. These imply that GISSMO has the potential to predict necking and localization of deformation of the 3D-printed ABS plastics for different load cases.
Yazar Ek Girişi:
Tek Biçim Eser Adı:
Thesis (Master)--İzmir Institute of Technology: Mechanical Engineering.

İzmir Institute of Technology: Mechanical Engineering--Thesis (Master).
Elektronik Erişim:
Access to Electronic Versiyon.
Ayırtma: Copies: